Kawasaki ZZR600 Scottoiler Installation Manual

download
Locate the vacuum – There is a rubber bung over a spigot on the inlet side of each carburetor. Remove one of these bungs and then press the Damper Elbow, part number 4, onto the spigot. Later models: These spigots might have vacuum pipes between them, in which case cut into the pipe and insert the T-Piece from the Scottoiler kit. Then press the Damper Elbow onto the third leg of the tee. The RMV can be mounted under the seat or behind the number plate. The more vertical the RMV the better and remember to avoid exhaust and engine components. For further information, see our easy step installation guide – ‘RMV Positions, General’ . The Dispenser Assembly, shown left , is routed along the underside of the Swingarm using Dispenser Mounting Sleeves, Cable Ties & Glue. Note: an epoxy resin (eg. Araldite) is req’d to bond the sleeves to the Swingarm. For further information see our easy step installation guide – ‘Dispenser Assemblies, General’ . The nib should feed the sprocket between the 6 & 7 o’clock positions, with the cut face facing outwards, as shown bottom left. Note: This is a generic image Once fitted, fill and prime the system and set the adjuster knob to ‘prime’. Start the engine and turn the adjuster knob until a flow of between 1 and 2 drops per minute is achieved. Check the condition of your chain after a ride, and then adjust as required.